Creality V4.2.X TMC Boards – Recommended VREF

These are the recommended VREFs for the V4.2.2 and V4.2.7 with Trinamic Drivers (TMC2208/TMC2225) from Creality. VREF is set by using a multimeter with power ON to the board and adjusting with a screwdriver. See our VREF video below for an example.

Be CAREFUL when adjusting as a slip of your screwdriver will damage the board permanently.

VREF Values

These VREF values are the recommended ones from Creality. If a VREF is set too high you can damage the board and/or stepper motor. If set too low, you will lose steps.

AxisVREF (in Volts)

VREF Setting Video

Table of Contents