EZABL

Adjusting the Mini Sensor Adjustment
The adjustment in the EZABL Mini has a metal stop tab that prevents from overshooting the adjustment. If you are not careful and/or you use a screwdriver to...
Wed, Dec 12, 2018 at 12:23 AM
Installation Guide
The EZABL Installation guide is also included in the Unified Firmware. You can download it here: TH3D Unified Firmware If you were sent here from Creali...
Wed, Dec 12, 2018 at 12:23 AM
Advanced EZABL and Printer Troubleshooting
Please go through the Z guide here: EZABL – Z Axis Troubleshooting Also make sure you match the mount type you are using on the printer to the firmware. F...
Wed, Dec 12, 2018 at 12:24 AM
Converting the EZ Connect to Direct Wire
If you purchased the EZ connect version and want to do away with the wall wart to power the sensor you can simply cut the wire off the 12V AC/DC adapter and...
Wed, Dec 12, 2018 at 12:25 AM
Direct Wire 12V/24V Power Info
See below for a wiring output from the CR-10 Power Supply. We recommend getting power from here. This is also applicable for MOST 12V/24V power supplies wit...
Wed, Dec 12, 2018 at 12:26 AM
Geeetech A10 3 Pin Z Wiring Notes
Wed, Dec 12, 2018 at 12:27 AM
How to fix “Slanting” Bed Leveling Result
Issue Even with bed leveling active the resulting 1st layer will have a “slant” to it where one side of the bed is higher than the other. There are a few t...
Wed, Dec 12, 2018 at 4:17 PM
Is your probe working well? (M48 Test)
One of the first things you should do after installing your Z-probe is check how well it works using the M48 command to test it. In our latest firmware ...
Wed, Dec 12, 2018 at 12:30 AM
Sensors and Gantry Grounding
Issue A small instance of machines like the Ender 3 exhibit issues with the EZABL sensors stay triggered due to poor/no grounding. We do have an option to ...
Wed, Dec 12, 2018 at 12:31 AM
Storing Bed Leveling Mesh & Updating Your Slicer
The EZABL and the Unified Firmware support storing your bed leveling mesh. What this means is that you only need to probe the bed initially and then you can...
Wed, Dec 12, 2018 at 12:34 AM