Download is available until [expire_date]
  • Version
  • Download 10
  • File Size 2.94 MB
  • File Count 1
  • Create Date May 8, 2023
  • Last Updated May 8, 2023

LMU Bearing Grease Packer - ThomLlama Design

Mirrored from https://www.thingiverse.com/thing:1974253 with Permission from ThomLlama


If you like my designs, please consider using the "tip designer" button and help support my continued effort to bring you new, useful and interesting things.

update with a new M4 cap and the 14x1.5 threaded for Super LubeTubes
New Cap can be printed and used with all version of the luber, just add a M4 screw. Screw will bottom out and cap continues down to seal to bearing.

These are just bearing grease packers for 8mm LMU bearings.

line up the slots with the balls and insert, screw on cap and inject grease.

this is setup right now to accept "toothpaste" style tubes of grease. I'll make adaptors as they are requested and I can get access to them to test.

right now I only have 24mm for standard size and 30mm for the standard pre-mounted in the aluminum case
Link to Zerk attachment remake/mod by Biggs2003 - https://www.thingiverse.com/thing:3153729/comments.

If you are using grease like mine it's VERY stiff, and takes a bit of effort to get it through out the whole bearing as the holes are kinda small..

••NOTE!! the whole thing is rather thin and small for 3D printing.. it will work but be careful not to over tighten or bend a lot as it'll probably break easy. Especially the tiny threaded section.••