Skip to main content

Search

How can we help?

Enter your question below or have a look around

TH3D Unified 1 Firmware Package

Comments

2 comments

  • Andreas Panzenboeck

    Amazing videos on how to flash bootloader and firmware for my CR10 Mini, thank you very much! One thing that caught me by surprise, when the new firmware is done, the E movement will only happen once nozzle is up to temp, good safety though.

    Thanks again for a very helpful and informative site

    Regards

    Andreas

    1
  • James

    If you have a CR-10s & have issues with your display (even with instructions), This is what fixed it for me:

     

    At the bottom of the Configuration.h I added

    #define ST7920_DELAY_1 DELAY_NS(200) // After CLK LOW
    #define ST7920_DELAY_2 DELAY_NS(400) // After DAT
    #define ST7920_DELAY_3 DELAY_NS(200) // After CLK HIGH

     

    Then reflashed. All is well now.

    1

Please sign in to leave a comment.