Skip to main content

Search

How can we help?

Enter your question below or have a look around

Ender 3 V2 Firmware + LCD Firmware | V4.2.2 Board

Comments

2 comments

  • Pedro Claudio

    Thank you so much for releasing this!!! I just wanted to share a couple of things I ran across updating the LCD firmware on my Ender 3 V2. 

    On step 2, I had to add a folder called DWIN_SET in my SD card and extract the files into that folder in order for the LCD to get to that orange screen described in the directions on step 6. Without that DWIN_SET folder, my LCD would not recognize I was trying to do an update and would just boot up as if nothing was on the SD card.

    Even after that orange screen was on for 30 seconds, when I booted the LCD back up, I never saw what is described in step 8 (Marlin and TH3D logos).

    I went ahead and proceeded as described with the printer board directions and once the printer booted up, I checked the Info section and confirmed that the firmware installed (Firmware version TH3D UFW 2.00). 

    I hope this helps others that may run into the same situation. Again, thanks for releasing this. Next up, installing EZABL Pro on this machine :) 

    0
  • Michael Bakker

    Hi There,

     

    I have an Ender 3 v2 printer and installed the Unified 2 firmware :-) I installed the latest production version  and the beta version but I still have the following problemen. When the printer is on and I put in a SD card nothing is happening. The printer is not reading the card and there is no option in the menu to reread the card. I have to turn off the printer and back on again to reread the card and see its contens. Is there an option in the firmware that will turn on auto read when you put in a SD card ?

     

    Cheers,

    Michael

    0

Please sign in to leave a comment.