Skip to main content

Search

How can we help?

Enter your question below or have a look around

Creality CR-10 V2 Firmware | V2.5.2 Board

Comments

5 comments

  • Tony Riek
    CR-10 V2 Firmware | V2.5.2 Board
    I compiled the firmware in VS without an issue. I uploaded to the V2, without a hitch. I did the eprom reset twice. Went to autohome and X & Y both home correctly. Z moves up and then nothing. I manually for home to X & Y. Perfect. Home Z, same result. Ideas??
    0
  • Tim

    Just tested it on our CR-10 V2 and its working correctly. Check your Z endstop connection and motor connections.

    0
  • Tony Riek

    The Z endstop is hooked into an EZABL pro. I flipped the switch inside to the down position and still had the issue. I had to revert back to U1.R2.B5 and it is working like a champ once again.

    0
  • Tim

    I wish I could isolate the issue but we also have an EZABL Pro connected to our CR-10 V2 with the same firmware build and it is working as intended with the EZABL and the stock endstop. I'd recommend downloading the firmware again in case you got a corrupt download. Also, make sure VSCode and its extensions as well as Python are up to date on your computer. Please make sure you are using VSCode to compile the firmware. It has not (and will not) been tested with the Arduino IDE.

    0
  • Tony Riek

    I downloaded a fresh copy this morning and using VSCode.  I made triple sure was up to date and installed correctly.  I set my items and it compiled without issues.  I then uploaded to the V2 without issue.  It rebooted and it prompted for eprom reset.  After that, I powered it down and back up.  Auto home worked like a champ.  I think it is all good now Tim...

    0

Article is closed for comments.