The Ender 3 V2 LCD is currently limited by its closed source firmware. You can remove the stock LCD and replace it with the Creality OEM LCD and a printed part.

Once the LCD is swapped you just flash the printer as an Ender 3, not an Ender 3 V2. This works with the Creality V4.2.X, SKR E3 Mini, and EZBoard boards when using our firmware.

LCD Screen: https://www.th3dstudio.com/product/creality-12864-oem-lcd-screen-cr-10-ender-3-ender-5-more-single-dual-cable-compatible-exp1-exp2-exp3-cables-included/ 

LCD Screen Mount (Mounts to the left side): https://www.thingiverse.com/thing:3941024

If the Thingiverse link is not working the STL files are attached to the bottom of this article for direct download.

Using the EZBoard with the Ender 3 V2 after the LCD is swapped

Once the LCD is swapped you can even put our EZBoard in there and just flash it with our Ender 3 firmware.

EZABL Settings for Ender 3 V2 with the EZBoard: If you swap the board and are using our EZBoard with our EZABL with the Ender 3 V2 OEM EZABL mount offsets are: #define NOZZLE_TO_PROBE_OFFSET { -48, -15, 0 }. These would get entered into the CUSTOM_PROBE section and you would also uncomment (or enable in the web config if you are using that to build the firmware) the CUSTOM_PROBE option.

We convert ours here at timestamp 13:00: