Ender 3 V2 – Swapping to the 12864 Creality LCD for more features


The Ender 3 V2 LCD is currently limited by its closed source firmware. You can remove the stock LCD and replace it with the Creality OEM LCD and a printed part.

Once the LCD is swapped you just flash the printer as an Ender 3, not an Ender 3 V2. This works with the Creality V4.2.X, SKR E3 Mini, and EZBoard boards when using our firmware.

LCD Screen: 


Creality OEM Metal Bracket: Ender 3/Ender 3 V2 – Creality 12864 LCD Mounting Bracket – TH3D Studio LLC

Printed LCD Screen Mount (Right hand side mount):

Printed LCD Screen Mount (Left hand side mount):

Using the EZBoard with the Ender 3 V2

Once the LCD is swapped you can put our EZBoard in there and just flash it with our Ender 3 firmware setting.

EZABL Settings for Ender 3 V2 with the EZBoard

If you swap the board and are using our EZBoard with our EZABL with the Ender 3 V2 OEM EZABL mount offsets are:

#define NOZZLE_TO_PROBE_OFFSET { -48, -15, 0 }

These would get entered in the CUSTOM_PROBE section and you would also uncomment (or enable in the web config if you are using that to build the firmware) the CUSTOM_PROBE option.

Video of the Conversion

We convert ours here at timestamp 13:00

Table of Contents