Details #
When upgrading to the EZBoard V2 you will need to connect the stock CRTouch sensor to the SERVO + Z-STOP header on the EZBoard. You can do this with Dupont Jumper wires which are completely reversible. Pictures of the wiring with the Dupont Jumpers are below.
Only the EZBoard V2 is supported on the SV01 Pro. We will not be updating the EZBoard Lite V1 code to support this printer as it is a discontinued product.
Stock ABL 5 Pin Connector Pinout #
Completed Wiring with Dupont Jumpers. Wrap with electrical tape as shown below after making the connections. #
