Menu
This tool is to help you calibrate the ESteps for your 3D printer. Just follow the steps below to get your new ESteps. The new value can be set by sending the Gcode command below to your printer or you can also put it into your printer firmware.
If you do set the ESteps with the GCode command, remember to save it to your EEPROM by sending an M500 command after. If you do not put the EStep number into your firmware it will revert to the firmware default when you reset the EEPROM.
Our website costs money to run and this is our full time job! You can support us directly by purchasing filament, printer parts, and 100’s of other upgrades right here
Best of all it is shipped from the USA with NO drop shipping and you get support from our team based right here in the USA.
Do you shop on Amazon? We’re also an affiliate so you can buy your favorite things AND support us with NO additional cost to you.
Just use our Amazon affiliate link below and we’ll get a small % of what you order.
Hours – M-F 10AM to 6PM CST | Closed Weekends
Phone – 312-858-TH3D(8433)
Address – 840 S. Lake Park Ave, BLDG 2, Hobart, IN 46342
In-Person By Appointment ONLY – Call or Email
NOTE: Phone lines close at 5PM on Friday
Website built & maintained by
Digital Forge Systems.
Links to 3rd party sites may be affiliate links where we earn a small commission when you make a purchase.