AnyCubic Chiron EZABL Control Board Connection Info

Chiron Specific Differences #

When installing the EZABL on the Chiron there are a few differences versus a standard machine. They are as follows:

  • The Z endstops are NOT replaced as they are optical and will not interfere with the gantry
  • You will connect to the S and G pins on the Z+ header with 2 male to female jumper wires that came with the Chiron LCD kit. (see pictures below)
  • Our Chiron LCD kit is REQUIRED to use the EZABL with the Chiron due to its stock LCD being very limited.

Aside from the above things mentioned, the rest of the EZABL installation is the same as the guide.

Z+ Connection Pictures #

Updated on July 12, 2022
Was this article helpful?