Voltage Jumper #
There is a voltage jumper on the module, make sure to set the voltage jumper to the printer voltage. This is a universal part for any 3D printer with a 12V or 24V DC heated bed.
Printed Parts Compatible with this product #
- https://www.thingiverse.com/thing:2976220
- https://www.thingiverse.com/thing:2861113
- https://www.thingiverse.com/thing:2847097
Installation notes #
If you are using a mount that requires you to screw the mosfet PCB to the mount make the screws you are using (not included) have the standard hex heads as seen in the installation video below and not a larger “pan head” type as larger head screws can touch components on the PCB.
CR-10 Mounting notes #
Use the basic mounting plate below and glue the plate with hot melt or super glue between the rear 40mm fan and the control board. This will allow for proper cooling of the MOSFET.
Installation Video #
Wiring Diagram #
