Ender 2 Pro Handle Spacer – Tough Extruder V2

If you are installing our Tough Extruder V2 to your Ender 2 Pro you will normally only be able to print to about 170mm instead of 180mm as the extruder hits the handle. You can either remove the handle or you can print this spacer to move the handle up about 10mm. You will need 2x M5x23-25mm length screws to re-attach the handle with the spacer installed.

The spacer IS directional so make sure to pay attention to the direction that it goes into the handle.

Icon
Ender 2 Pro Handle Spacer – Tough Extruder V2
Was this article helpful?