EZABL Printer & Firmware Support List

Firmware and Technical Support Details #

While the EZABL will work with almost any printer that runs open-source firmware (Marlin, Rep-Rap, Klipper, etc), our technical support for firmware assistance covers the printers on the supported list below with their stock control boards or EZBoard (on supported models) when running our Unified Firmware package. Most touchscreen models are NOT supported due to their limited, closed-source firmware.

Supported Model List #

  • ADIMLab Gantry i3
  • Alfawise U10
  • Anet A2
  • Anet A6
  • Anet A8
  • Anet A8 Plus
  • Anet E10
  • Anet E12
  • Anet E16
  • AnyCubic Chiron – (needs LCD kit)
  • AnyCubic Mega Zero V1
  • AnyCubic Mega Zero V2
  • Artillery AL-4
  • Creality CR-10
  • Creality CR-10 Mini
  • Creality CR-10 S4
  • Creality CR-10 S5
  • Creality CR-10S
  • Creality CR-10S Mini
  • Creality CR-10S S4
  • Creality CR-10S S5
  • Creality CR-10 V2
  • Creality CR-10 V3
  • Creality CR-10S Pro – (needs LCD kit)
  • Creality CRX – (needs LCD kit)
  • Creality Ender 2
  • Creality Ender 2 Pro
  • Creality Ender 3/3 Pro
  • Creality Ender 3 MAX
  • Creality Ender 3 S1 – (LCD Kit recommended, works with stock LCD)
  • Creality Ender 3 V2 – (LCD Kit recommended, works with stock LCD)
  • Creality Ender 4
  • Creality Ender 5/5 Pro
  • Creality Ender 5 Plus (needs LCD kit) – If you want to not have to cut your stock Z endstop wire add on the Ender 5 Plus/Ender 6 Endstop Cable on the EZABL Page.
  • Creality Ender 6 (needs LCD kit) – If you want to not have to cut your stock Z endstop wire add on the Ender 5 Plus/Ender 6 Endstop Cable on the EZABL Page.
  • Geeetech A10 V1/A10 V2
  • Geeetech A20
  • Kingroon KP3
  • Kingroon KP3S
  • Sovol SV01
  • Sunlu S8
  • Tevo Tornado
  • Tevo Tarantula Pro
  • Voxelab Aquila X1 – (LCD Kit recommended, works with stock LCD)
  • Wanhao Duplicator i3 (and rebrands)
  • Wanhao Duplicator i3 Mini (and rebrands)
  • Zyltech Gear V1/V2/V3 – Needs EZABL Z Cable in addition to the kit

Other Printers #

  • Setting up EZABL on Vanilla Marlin or Duet?. The EZABL works like a normally open endstop switch and will physically work with boards running Marlin or RepRap (Duet) but the included support does not cover getting your custom machine setup but support on a custom machine is available at an hourly rate. Otherwise, you can always check out our communities for getting the EZABL working on a non-supported board/printer here: Community.TH3DStudio.com
Updated on August 2, 2022
Was this article helpful?